Jeep Liberty: To Open And Close The Hood Lights
Two latches must be released to open the hood.
1. Pull the hood release lever located under the left side of the instrument panel.
Hood Release
2. Outside of the vehicle, locate the safety latch lever between the grille and hood opening (left of center when facing hood). Push the safety latch lever to the right and then raise the hood.
Underhood Safety Latch
Use the hood prop rod to secure the hood in the open position. Place the upper end of the prop rod in the hole on the underside of the hood.
CAUTION!
To prevent possible damage:
• Before closing hood, make sure the hood prop rod is fully seated into its storage retaining clips.
• Lower the hood to approximately 6 in (15.2 cm) above the closed position and drop the hood to latch it.
• Never drive your vehicle unless the hood is fully closed, with both latches engaged.
WARNING!
Be sure the hood is fully latched before driving your
vehicle. If the hood is not fully latched, it could open
when the vehicle is in motion and block your vision.
Failure to follow this warning could result in serious injury or death.
Easy Entry/Exit Seat (Available With Memory Seat Only)
This feature provides automatic driver seat positioning to enhance driver mobility when entering and exiting the vehicle. The distance the driver seat moves depends on where you have the driver ...Lights
...See also:
Airbag Supplemental Restraint System (SRS)
...
Trip computer
To operate the trip computer, use the A
switch.
When the ignition switch is in the ON position,
modes of the trip computer can be selected by
pushing the switch A briefly.
Each time the ...
Important Safety Precautions
To eliminate potential hazards, read
the instructions before you begin,
and make sure you have the tools
and skills required.
Make sure your vehicle is parked
on level ground, the parking bra ...