Jeep Liberty: To Exit Remote Start Mode Without Driving The Vehicle
Press and release the REMOTE START button one time or allow the engine to run for the entire 15-minute cycle.
NOTE: To avoid unintentional shut downs, the system will disable the one-time press of the REMOTE START button for two seconds after receiving a valid Remote Start request.
To Enter Remote Start Mode
Press and release the REMOTE START button on the RKE transmitter twice within five seconds. The parking lights will flash and the horn will chirp twice (if programmed). Then, the engine will ...To Exit Remote Start Mode And Drive The Vehicle
Before the end of the 15-minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, insert the key in ...See also:
Selecting a language (English, French or Spanish)
1 Push and hold the “AUTO”
button for 6 to 12 seconds.
The screen will turn on and
the indicator will turn green.
2 Push the “AUTO” button.
Each time the “AUTO” button
is pushed an ...
Manual tuning
Turn the “TUNE/TRACK/CH” dial clockwise
to increase the tuning frequency and
turn the “TUNE/TRACK/CH” dial counterclockwise
to decrease it.
Each time the dial is turned, the frequency ...
Seatbelt and SRS airbag
- All persons in the vehicle should
fasten their seatbelts BEFORE
the vehicle starts to move. Otherwise,
the possibility of serious
injury becomes greater in the
event of a sudden stop o ...