Jeep Liberty: To Exit Remote Start Mode And Drive The Vehicle - How To Use Remote Start - Remote Starting System — If Equipped - Things To Know Before Starting Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: To Exit Remote Start Mode And Drive The Vehicle

Before the end of the 15-minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, insert the key into the ignition switch and turn the switch to the ON/RUN position.

NOTE: The ignition switch must be in the ON/RUN position in order to drive the vehicle.

    To Exit Remote Start Mode Without Driving The Vehicle
    Press and release the REMOTE START button one time or allow the engine to run for the entire 15-minute cycle. NOTE: To avoid unintentional shut downs, the system will disable the one-time press o ...

    See also:

    Roll Stability Controlâ„¢ (RSC)
    Roll Stability Control (RSC ) may help to maintain roll stability of the vehicle during adverse maneuvers. RSC operates by detecting the vehicle’s roll motion and the rate at which it changes and ...

    Start
    Ignition switch with remote key inserted ( see page 82 for more information on ignition modes) WARNING Before starting the engine: • Fasten the seat belt. • Check that the seat, steering w ...

    Fastening the seatbelt
    - Never use a belt that is twisted or reversed. In an accident, this can increase the risk or severity of injury. - Keep the lap belt as low as possible on your hips. In a collision, th ...