Ford Escape: Tire change procedure - CHANGING THE TIRES - Roadside Emergencies - Ford Escape Owner's ManualFord Escape: Tire change procedure

transmission alone will not prevent the vehicle from moving or WARNING: When one of the front wheels is off the ground, the transmission alone will not prevent the vehicle from moving or slipping off the jack, even if the vehicle is in P (Park) (automatic transmission) or R (Reverse) (manual transmission).

change a tire, be sure the parking brake is set, then block (in WARNING: To help prevent the vehicle from moving when you change a tire, be sure the parking brake is set, then block (in both directions) the wheel that is diagonally opposite (other side and end of the vehicle) to the tire being changed.

could be seriously injured. WARNING: If the vehicle slips off the jack, you or someone else could be seriously injured.

vehicle close to moving traffic. Pull far enough off the road to WARNING: Do not attempt to change a tire on the side of the vehicle close to moving traffic. Pull far enough off the road to avoid the danger of being hit when operating the jack or changing the wheel.

1. Block the diagonally opposite wheel.

2. Loosen each wheel lug nut

2. Loosen each wheel lug nut one-half turn counterclockwise but do not remove them until the wheel is raised off the ground.

Before placing the jack under the vehicle, NOTE the jack locations:

Before placing the jack under the vehicle, NOTE the jack locations:

• Front

View shown from rear of front tire.

Position the jack directly below the protruding bolt.

• Rear

• Rear

View shown from forward of rear tire. Position the jack directly below the stud on the rear trailing arm.

3. Position the jack according to the

3. Position the jack according to the guides and turn the jack handle clockwise until the tire is a maximum of 1 inch (25 mm) off the ground.

Be sure to place the jack away

Be sure to place the jack away from the rear edge of the rocker to avoid damaging the rear tire spoiler (pictured).

Never use the differentials as a

Never use the differentials as a jacking point.

risk of personal injury, do not WARNING: To lessen the risk of personal injury, do not put any part of your body under the vehicle while changing a tire.

Do not start the engine when your vehicle is on the jack. The jack is only meant for changing the tire.

4. Remove the lug nuts with the lug nut wrench.

4. Remove the lug nuts with the lug nut wrench.
5. Replace the flat tire with the spare tire, making sure the valve stem is facing outward. Reinstall lug nuts until the wheel is snug against the hub.
Do not fully tighten the lug nuts until the wheel has been lowered.
6. Lower the wheel by turning the jack handle counterclockwise.
7. Remove the jack and fully tighten the lug nuts in the order shown.

Refer to Wheel lug nut torque specifications later in this chapter for the proper lug nut torque specification.

Stowing the jack and tools

Removing the spare tire or spare tire and tether (if equipped)
1. Insert the lug wrench through the access hole in the rear bumper. 2. Turn the handle counterclockwise and lower the spare tire until it can be slid rearward and the cable is slack. 3. Slide t ...

Stowing the jack and tools
• Make sure the jack is fully lowered. • Reclip the tools onto the jack making sure that the tools are fully contained by the clips as shown. • Reinstall the jack in the pocket with the l ...

See also:

Towing Tips
Before setting out on a trip, practice turning, stopping, and backing the trailer in an area located away from heavy traffic. ...

Anti-theft system
No modifications or additions should be made to the anti-theft system. Such changes could cause the system to malfunction. ...

Spot Light
Spot Light Push the switch to turn on the light and push it again to turn off the light. ...