Range Rover Evoque: Stalled adjustment
If seat
movement stops unexpectedly
during adjustment check for any
obstructions and remove.
Once any obstructions have been removed the
seat adjustment mechanism can be reset as
follows.
Operate the button again to continue the stalled
adjustment. When seat movement resumes
hold the button until the end of travel in that
direction has been reached. The seat position
can now be carried out as normal.
Note: If no obstructions can be seen, but
normal adjustment cannot be carried out
without stalling, contact your Land Rover
Dealer/Approved Repairer.
READ NEXT:
The driver
and front seat passenger
must not ride with the seat fully
reclined.
Do not adjust
the seat while the
vehicle is moving.
The seat, head restraint, seat belt and airbags,
all con
Front seat positions can be saved to vehicle
memory.
Once you have adjusted the power operated
driver’s seat and the exterior mirrors, the
vehicle can memorise the settings for future
use. See
When Easy entry/exit is configured, the driver’s
seat will automatically lower when the ignition
is switched off and the door release lever is
used. Upon returning to the vehicle, when the
drive
SEE MORE:
Special Tool(s)
205-857
Remover, Halfshaft
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
JLR-303-1591
Lifting Bracket, Engine - Rear
General Equipment
Transmission jack
NOTE: Some variation in the illustrations may occur, but the essential
information is alway
Component Location
COMPONENT LOCATION
Heater assembly
Electric booster heater
Overview
OVERVIEW
Due to the slower warm up times associated with the diesel engine, an
electric booster heater may be fitted to increase
heater performance. The electric booster heater does this by heating the air
© 2011-2024 Copyright www.rrevoque.org