Subaru Forester: Sound controls and audio settings - Power and audio controls - Audio - Subaru Forester Owner's ManualSubaru Forester: Sound controls and audio settings

NOTE
- SPEED VOLUME CONTROL is a function that automatically adjusts the volume according to the vehicle speed.

As the vehicle speed increases, the audio volume automatically increases to match the vehicle speed, in order to create a pleasant listening environment even as the driving noise increases.

- For type B audio, SRS CS Auto is equipped. SRS CS Auto creates a 5.1ch equivalent surround field using 6 or 7 speakers that are installed in the vehicle.

- For type D audio, SRS TruBass and FOCUS are equipped.

- SRS Sound features:
(1) Sound originating from door mount speakers can be heard at ear level (built in SRS FOCUS effect) (type B and D audio).

(2) Ultra rich bass sound can be obtained from standard door mount speakers (built in SRS TruBass effect) (type B and D audio).

(3) Surround sound can be obtained from 2-channel stereo sources such as CD, MP3 and FM (built in SRS Circle Surround II effect) (type B audio).

(4) SRS CS Auto can position the center channel image in the center of the vehicle’s windshield. This eliminates the need for a center speaker (built in SRS Circle Surround II phantom center and SRS FOCUS effects) (type B audio).

- CS Auto, SRS and “trademarks of SRS Labs, Inc.” symbol are trademarks of SRS Labs, Inc.

- CS Auto technology is incorporated under license from SRS Labs, inc.

- TruBass, FOCUS, SRS and “symbol are trademarks of SRS Labs,” symbol are trademarks of SRS Labs, Inc.

- TruBass and FOCUS technologies are incorporated under license from SRS Labs, Inc.

Tone and balance control (type A, B and C audio)

Power switch and volume control
The dial is used for both power (ON/OFF) and volume control. The radio is turned ON and OFF by pushing the dial, and the volume is controlled by turning the dial. ...

Tone and balance control (type A, B and C audio)
Each brief press of the “TUNE/TRACK/ CH” dial changes the control modes in the following sequence. Choose the preferred level for each mode by turning the “TUNE/TRACK/CH” dial. The ...

See also:

Replacement of brake pad and lining
The front disc brake and the rear disc brake have audible wear indicators on the brake pads. If the brake pads wear close to their service limit, the wear indicator makes a very audible scra ...

License plate light
1. Remove the mounting screws using a Phillips screwdriver. 2. Remove the cover and lens. 3. Pull the bulb out of the socket. 4. Install a new bulb. 5. Reinstall the lens and cover. 6. Tighte ...

Rolling code device equipment programming
Note: The assistance of a second person, may make the following steps quicker and easier. Once the button has been pressed there are only 30 seconds in which to complete Step 3. 1. At the garage d ...