Volvo XC60: Settings
Settings for Lane Departure Warning can be made in the menu system by pressing My Car. Go to Settings Car settings Driver support systems Lane Departure Warning.
There are two alternatives:
On at start-up: This selection switches LDW on each time the engine is started. Otherwise, the system will be in the mode that it was in when the engine was switched off.
Increased sensitivity: This selection increases the function’s sensitivity. Warnings will be given at an earlier stage and fewer limitations apply. When this setting is being used, the system only needs to monitor lane marker lines on one side of the vehicle to change status to Lane Depart Warn Available.
Operation and function
LDW can be switched on or off by pressing the button on the center console. A light in the button illuminates when the function is on. The trip computer display shows Lane Depart Warn Standby ...See also:
Engine break-in recommendations
A long break-in period is not required for the engine and
drivetrain (transmission and axle) in your vehicle.
Drive moderately during the first 300 miles (500 km).
After the initial 60 miles (10 ...
System monitors
A diagnostic system continually monitors
the readiness of the seatbelt pretensioner
while the vehicle is being driven. The
seatbelt pretensioners share the control
module with the SRS airbag s ...
High-Beam On Light
The high&-beam on light comes on when the high-beam headlamps are in use.
See Headlamp High/Low-Beam Changer on page 6‑2 for more information. ...