Range Rover Evoque: Sensor blockage
If one of the sensors is completely obscured
the BSM system is automatically disabled, the
warning indicator dot is displayed in the
exterior mirror and the message BSM sensor
blocked appears in the message centre.
Note: Blockage testing is only initiated when
vehicle speed is above 32km/h (20mph) and
will take at least two minutes of accumulated
driving above this speed, to determine that the
sensor is blocked.
If the sensors become blocked, then please
check that there is nothing obscuring the rear
bumper and that it is clear from ice, frost and
dirt.
Note: The BSM system is inoperative while a
trailer is attached and the trailer socket is used.
READ NEXT:
If a fault with one of the radar sensors is
detected, an amber warning indicator dot is
displayed in the exterior mirror and the
message BSM not available is displayed in the
message centre.
Note
Do not use the transceiver
with any
garage door opener that lacks the
safety stop and reverse feature as
required by safety standards.
When programming the transceiver to
a garage door opener
SEE MORE:
When the misfuelling device is
activated, it may cause fuel to be
discharged from the filler neck.
Note: It is the driver’s responsibility to fill the
vehicle with the correct fuel. The diesel
misfuelling protection device only reduces the
risk of filling the vehicle with the incorrect fuel
Removal
CAUTION: LH illustration shown, RH is similar.
NOTES:
Removal steps in this procedure may contain installation details.
The ignition must be switched off.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Front Bumper Cover (501-19 B
© 2011-2024 Copyright www.rrevoque.org