Range Rover Evoque: Selecting valet mode
Valet mode allows the vehicle to be driven, e.g.,
by a parking attendant, but leaves the tailgate
locked and restricts use of the touch screen.
This prevents access to telephone numbers,
navigation addresses and audio system
settings.
From the Home menu, select Valet:
Enter a four digit Personal identification
Number (PIN) (personally chosen). On
completion, touch the OK soft key.
If you wish to cancel the PIN, select Delete.
After entering the PIN, you will be prompted to
enter the PIN again. Enter the same PIN and
touch OK to confirm.
A pop-up screen is displayed, confirming your
vehicle is now in Valet mode.
READ NEXT:
The interior protection feature of the full alarm
system may be temporarily disabled via Alarm
sensors in the Vehicle Settings menu. See 56,
VEHICLE INFORMATION AND SETTINGS
MENU.
Note: If the in
In certain markets, a battery backed sounder is
fitted. This device will sound if it or the vehicle
battery is disconnected while the security
system is armed.
The tilt sensor detects any change to the
vehicle’s angle to the ground. When the alarm
is armed and the vehicle is double locked, any
change in the vehicle’s angle will activate the
tilt alar
SEE MORE:
Removal
NOTES:
The removal of this component involves cutting an aperture in the evaporator
housing wall and cutting through the
high and low pressure A/C lines. A service repair kit is supplied to cover this
procedure.
Removal steps in this procedure may contain installation details.
1. Disconne
Special Tool(s)
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspension.
Do not allow halfshafts to hang unsupported at one end or joint damage will
occur.
Make sure the halfshaft constant vel
© 2011-2024 Copyright www.rrevoque.org