Subaru Forester: Scan (type A, B and C audio)
The scan mode lets you listen to the first 10 seconds of each track/file in succession.
Press the “SCAN” button to start scanning upward beginning with the track/ file(s) following the currently selected one.
After all track/file(s) in the disk/folder have been scanned, normal playback will be resumed. To cancel the scan mode, press the “SCAN” button again.
NOTE
The scan mode will be cancelled if you
perform any of the following steps.
- Press the “RPT” button
- Turn the “TUNE/TRACK/CH” dial
- Press the “” or “”
side of the “FOLDER/PTY/CAT” button
- Press the “” button
- Press the disc select button (type B audio)
- Select the mode other than CD mode
- Press the “LOAD” button when there is free space in the CD magazine (type B
audio)
- Turn off the power of the audio equipment
- Turn the ignition switch to the “LOCK” position
Random playback
To playback a track/file(s) at random, press the following button (random button) while the track/file is playing. *1: For type A, B and C audio, press the button for 0.5 second or longer. * ...Display selection (type A, B and C audio)
If you press the “TEXT” button during playback, the display will change as shown in the following sequence. For CD-DA: For MP3/WMA/AAC: For iPod®: ...See also:
Battery Replacement
Replace the battery if the REPLACE BATTERY IN REMOTE KEY message displays in
the DIC. See ЃgReplace Battery in Remote KeyЃh under Key and Lock Messages on page
5.29.
The battery is not recharge ...
Fuel information
Your vehicle must use only unleaded gasoline.
Select octane rating 87 (Research Octane Number 91) or higher. Use
of unleaded gasoline with an octane rating lower than 87 may result
in engine knocki ...