Mercedes-Benz GLK-Class: Restarting the tire pressure monitor
WARNING
It is the driver's responsibility to set the tire pressure to the recommended cold tire pressure. Underinflated tires affect the ability to steer or brake the vehicle. You might lose control over the vehicle.
When you restart the tire pressure monitor, all existing warning messages are deleted and the warning lamps go out. The monitor uses the currently set tire pressures as the reference values for monitoring.
The tire pressure monitor must be restarted when you set the tire pressure to a new value (as a result of changed drive or load characteristics, for example). The tire pressure monitor then monitors the new tire pressure values.
Restart the tire pressure monitor after you have set the tire pressure to the value recommended for the desired driving situation (). Only correct tire pressures on cold tires. Comply with the recommended tire pressures on the Tire and Loading Information placard on the B-pillar on the driver's side. Additional tire pressure values for driving at high speeds or with heavy loads can be found in the tire pressure table on the inside of the fuel filler flap.
- Make sure that the tire pressure is correct on all four wheels.
- Make sure that the SmartKey is in position 2 in the ignition lock.
- Press the or button on the steering wheel to select the Service menu.
- Press the or button to select Tire Pressure.
- Press the button. The multifunction display shows the current tire pressure of the individual tires or the Tire pressures will be displayed after driving a few minutes message.
- Press the button. The Use Current Pressures as New Reference Values message appears in the multifunction display.
If you wish to confirm the restart:
- Press the button.
The Tire Press. Monitor Restarted message appears in the multifunction display. After driving for a few minutes, the system checks whether the current tire pressures are within the specified range. The new tire pressures are then accepted as reference values and monitored.
If you wish to cancel the restart:
X Press the button.
- The tire pressure values stored at the last restart will continue to be monitored.
Tire pressure monitor warning messages
If the tire pressure monitor detects a significant pressure loss on one or more tires, a warning message is shown in the multifunction display. A warning tone also sounds and the tire pressure war ...See also:
If the light is blinking
If the light is blinking while driving, an
engine misfire condition has been detected
which may damage the emission
control system.
To prevent serious damage to the emission
control system, y ...
Detaching and storing the cargo net
Detach guide rod 2 from bracket 1 ().
Press the red button on the upper and lower guide rods.
Fold the cargo net and roll it up.
Close the two Velcro fasteners on the cargo net holder.
...
Setting the playing speed (only when
the audiobook is playing) (type D audio)
Each time you briefly press (the
“RPT” button) while the audiobook is
playing, the playing speed changes in
the following sequence.
...