Range Rover Evoque: Reprogramming a single garage door opener button
To programme a device to a previously
programmed button:
1. Press and hold the desired
pre-programmed HomeLink button for at
least 20 seconds, but no longer than 30
seconds, until the indicator lamp begins to
flash.
2. Without releasing the button, position the
hand-held transmitter approximately 50 to
150 mm (2 to 6 inches) away from the
HomeLink transceiver, keeping the
indicator lamp in view.
3. Carry out Step 3 of Programming.
READ NEXT:
For first time programming, ensure that the
engine is switched off:
1. Ensure that the ignition is on (but with the
engine switched off).
2. Press and hold the two outer HomeLink
buttons. Keep th
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
Continue to press and hold the desired
HomeLin
It is recommended that when
you sell or
dispose of the vehicle, the programmed
HomeLink buttons be erased for
security purposes.
For information on the range of available
compatible products or
SEE MORE:
The powered tailgate may lose its position
memory if there are multiple object detections
or if battery voltage is low. Powered operation
may be inhibited. To reset the tailgate;
1. Manually close the tailgate.
2. Press a release switch.
3. Allow the tailgate to power fully open or to
the pre
When refuelling ensure that
all
windows, doors, and sunroof are fully
closed, particularly if young children
or animals are in the vehicle.
Do not attempt to fill the tank to its
maximum capacity. If the vehicle is to
be parked on a slope, in direct
sunlight, or high ambient
temperature,
© 2011-2024 Copyright www.rrevoque.org