Ford Escape: Replacing high-mount brake lamp bulbs - Replacing headlamp bulbs - Bulb Replacement - Lights - Ford Escape Owner's ManualFord Escape: Replacing high-mount brake lamp bulbs

1. Remove the two screws and move the lamp assembly away from the liftgate.

2. Remove the bulb holder from the

2. Remove the bulb holder from the lamp assembly by pressing the snaps.

3. Pull the bulb straight out of the

3. Pull the bulb straight out of the socket and push in the new bulb.

Install the new bulbs in reverse order.

Replacing license plate lamp bulbs

    Replacing tail/stop/turn/backup lamp bulbs
    The tail/stop/turn/sidemarker/backup lamp bulbs are located in the same portion of the tail lamp assembly, one just below the other. Follow the same steps to replace either bulb: 1. Make sure the ...

    Replacing license plate lamp bulbs
    1. Make sure the headlamp switch is in the off position. 2. Press the lever and carefully pry the license plate lamp assembly (located above the license plate) from the liftgate. 3. Rotate the b ...

    See also:

    Stopping and securing the vehicle
    1. Park on a level surface, set the parking brake and activate hazard flashers. 2. Place gearshift lever in P (Park) (automatic transmission) or R (Reverse) (manual transmission) and turn engine ...

    Flat towing
    Towing your vehicle with all four wheels on the ground is sometimes called flat towing. This method is sometimes used when towing a vehicle behind a recreational vehicle, such as a motor home. ...

    To Set A Desired Speed
    Turn the Electronic Speed Control ON. When the vehicle has reached the desired speed, press the SET (-) button and release. Release the accelerator and the vehicle will operate at the selected s ...