Volvo XC60: Removal
Switch off the ignition, remove the remote key from the ignition slot and wait at least 5 minutes before disconnecting the battery so that all information in the vehicle's electrical system can be stored in the control modules.
1 Open the clips on the front cover and remove the cover.
2 Release the rubber molding so that the rear cover is free.
3 Remove the rear cover by pulling it away.
4 1 Detach the black negative cable.
2 Detach the red positive cable
3 Detach the ventilation hose from the battery
4 Loosen the screw holding the battery clamp.
5Move the battery to the side and lift it up.
WARNING
PROPOSITION 65 WARNING!
Battery posts, terminals, and related accessories
contain lead and lead compounds,
chemicals known to the state of California
to cause cancer and reproductive harm.
Wash hands after handling.
Changing
WARNING
Connect and disconnect the positive and
negative cables in the correct sequence. ...
Installation
1. Lower the battery into the battery box.
2. Move the battery inward and to the side
until it reaches the rear edge of the box.
3. Tighten the clamp that secures the battery.
4. Connect the ve ...
See also:
Using a warm water washer
- Keep a good distance of 12 in (30 cm)
or more between the washer nozzle and
the vehicle.
- Do not wash the same area continuously.
- If a stain will not come out easily, wash
by hand. Some w ...
Programming for entrance gates and garage door openers in Canada
1. Unplug the motor of the entrance gate
or garage door opener from the outlet.
NOTE
If any of the HomeLinkВ® buttons are
already programmed for other devices,
skip step 2 because it clears t ...
Storing wheels
Store wheels that are not being used in a cool, dry and preferably dark place.
Protect the tires from oil, grease, gasoline and diesel. ...
