Jeep Liberty: Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) —
If Equipped
The following messages will display in the EVIC if the
vehicle fails to remote start or exits remote start prematurely:
• Remote Start Aborted — Door Ajar
• Remote Start Aborted — Hood Ajar
• Remote Start Aborted — L/Gate Ajar
• Remote Start Aborted — System Fault
• Remote Start Aborted — Fuel Low
The EVIC message stays active until the ignition is turned to the ON/RUN position.
How To Use Remote Start
All of the following conditions must be met before the
engine will remote start:
• Shift lever in PARK.
• Doors closed.
• Hood closed.
• Liftgate closed.
• Hazard switch off.
...
To Enter Remote Start Mode
Press and release the REMOTE START button
on the RKE transmitter twice within five seconds.
The parking lights will flash and the horn
will chirp twice (if programmed). Then, the
engine will ...
See also:
Illuminated entry
The interior lights come on when you open any door or
use the Remote Keyless Entry (RKE) transmitter to unlock
any door. They will remain on for approximately
30 seconds after all doors are clos ...
Trip information
Without Display Audio system
Push the “DISP” button to display
trip information.
Display items can be switched
by pressing the “DISP” button.
With Display Audio system
Push the “DI ...
Pre-towing tips
- Be certain your vehicle maintains a level
position when a loaded or unloaded trailer is
hitched. Do not drive the vehicle if it has an
abnormal nose-up or nose-down condition;
check for impr ...
