Volvo XC60: Reinserting the headlight housing
When reinserting the housing, be sure that the long locking pin (to the left in the illustration) is securely in place in both of its retaining clamps.
1. Plug in the connector until it clicks into place.
2. Reinstall the headlight housing and locking pins. Check that they are correctly inserted. The headlight housing must be properly inserted and secured in place before the lighting is switched on or the remote key is inserted into the ignition slot.
3. Check that the lights function properly.
The headlight wiring must be connected and the housing must be securely in place before the ignition is switched on.
Removing the headlight housing
1. Switch off the ignition by briefly pressing the START/STOP ENGINE button. 2. Remove the remote key from the ignition slot1. 3. (Upper illustration under "Headlight housing"). &nb ...Removing the cover to access the bulbs
NOTE Before starting to replace a bulb, see page 322. 1. Open the retaining clamps by pressing them to the sides. 2. Pull the cover straight out. Reinstall the cover in the reverse order. ...See also:
Replacement sensor
Should the sensor require replacing, it should
be carried out by a Dealer/Authorised Repairer.
A replacement sensor must be fitted to a
running wheel in order to be recognised by the
system. The v ...
Air vents in the door pillars
a Closed
b Open
c Horizontal airflow
d Vertical airflow
Direct the outer air vents toward the side windows
to defrost.
Direct the vents into the passenger compartment
to help maintain the d ...
Trip/Fuel Menu Items
Press the MENU button until Trip/ Fuel Information Menu is displayed. Then press
to scroll through the following menu
items:
○ Trip 1
○ Trip 2
○ Fuel Range
○ Average Fu ...