GMC Terrain: Rear Wiper Blade Replacement - Wiper Blade Replacement - Vehicle Checks - Vehicle Care - GMC Terrain Owner's ManualGMC Terrain: Rear Wiper Blade Replacement

The rear wiper blade and wiper arm have a cover for protection. The cover must be removed before the wiper blade can be replaced. To remove the cover:

1. Slide a plastic tool under the cover and push upward to unsnap.

1. Slide a plastic tool under the cover and push upward to unsnap.
2. Slide the cover towards the wiper blade tip to unhook it from the blade assembly.
3. Remove the cover.
4. After wiper blade replacement, ensure that cover hook slides into the slot in the blade assembly.
5. Snap the cover down to secure.

To remove the wiper blade:

1. Lift the wiper arm away from the windshield.

A. Wiper Arm

A. Wiper Arm
B. Release Lever
C. Blade Assembly

2. Push the release lever (B) to disengage the hook and push the wiper arm (A) out of the blade assembly (C).

3. Push the new blade assembly securely on the wiper arm until the release lever clicks into place.

4. Replace the wiper cover.

    Front Wiper Blade Replacement
    To replace the front wiper blades: 1. Lift the wiper arm from the windshield until no further movement is possible. 2. Press the square button on the top side, at the end of the wiper arm, and p ...

    Headlamp Aiming
    The headlamp aiming system has been preset at the factory. If the vehicle is damaged in an accident, the aim of the headlamps may be affected and adjustment may be necessary. It is recommended tha ...

    See also:

    Weather Strip Care
    Lubricate the weather strips periodically with MOPAR Weather Strip Lubricant or equivalent, to keep them soft and pliable. ...

    Determining compatibility of tire and vehicle load capacities
    The sum of four tires’ maximum load ratings must exceed the maximum loaded vehicle weight (“GVWR”). In addition, sum of the maximum load ratings of two front tires and of two rear tire ...

    Global closing
    Ensure that no children, pets, or obstructions are in any open aperture before operating global closing. Ensure that all doors are closed. Press and hold the Smart Key lock button for 3 seconds ...