Subaru Forester: Rear windows side seating position
Rear windows side seating position
1) Head restraint
2) Release button
To remove:
While pressing the release button, pull out the head restraint.
To install:
Install the head restraint into the holes that are located on the top of the seatback until the head restraint locks.
Head restraint adjustment
Both the rear window side seats and the rear center seat are equipped with head restraints. - Never drive the vehicle with the head restraints removed because they are designed to reduce ...Rear center seating position
The head restraint is not intended to be used at the lowest position. Before sitting on the seat, raise the head restraint to an appropriate position depending on your sitting height. ...See also:
Setting guidance volume
To set the guidance volume, perform the
following procedure.
1. Select the “GUIDANCE VOL”/“GUIDANCE
VOLUME” menu.
2. Set the guidance volume by operating
the “TUNE/TRACK/CH” dial. ...
Drip wipe
If the drip wipe function is configured, the
wipers will operate four seconds after a
wash/wipe cycle has finished, to clear any
remaining drips from the windscreen.
This function can be enabled ...
Fasten and Position the Seat Belts
Insert the latch plate into the buckle,
then tug on the belt to make sure the
belt is securely latched. Check that
the belt is not twisted, because a
twisted belt can cause serious
injuries ...