Range Rover Evoque: Programming

Programming
Programming

With the engine switched off; 1. Ensure that the ignition system is on.

2. Hold the signal emitting end of the original garage door opener hand-held transmitter 50 to 150 mm (2 to 6 inches) away from the HomeLink transceiver in the rear-view mirror, keeping the indicator lamp in view.

3. Simultaneously press and hold both the chosen HomeLink button, as shown above, and the hand-held transmitter button. Keep both buttons pressed. The indicator lamp will flash slowly at first and then change to a fast flash. When the indicator lamp flashes rapidly, release both buttons. The rapid flashing lamp indicates successful programming.

4. If, after 60 seconds, the indicator lamp does not flash rapidly, release both the HomeLink and the hand-held transmitter buttons and repeat the procedure starting with Step 2. Position the hand-held transmitter at a different angle and/or distance.

5. Press and hold the HomeLink opener button and observe the indicator lamp.

- If the indicator is continuous, programming is complete and your device should operate when the HomeLink opener button is pressed and held for approximately 1 to 2 seconds and then released.

- If the indicator lamp blinks rapidly for two seconds and then illuminates continuously, proceed with the following programming instructions for rolling code device equipment.

READ NEXT:

 Rolling code device equipment programming

Note: The assistance of a second person, may make the following steps quicker and easier. Once the button has been pressed there are only 30 seconds in which to complete Step 3. 1. At the garage d

 Reprogramming a single garage door opener button

To programme a device to a previously programmed button: 1. Press and hold the desired pre-programmed HomeLink button for at least 20 seconds, but no longer than 30 seconds, until the indicator l

 To erase all programming

For first time programming, ensure that the engine is switched off: 1. Ensure that the ignition is on (but with the engine switched off). 2. Press and hold the two outer HomeLink buttons. Keep th

SEE MORE:

 Headlamp washers

The optional headlamp power wash operates automatically with the windscreen wash and will operate only If the headlamps are switched on and there is sufficient washer fluid in the reservoir. Headlamp wash operates every fourth operation of the screen washers, provided the headlamps are still

 Petrol and Petrol-Ethanol Fuel Systems Health and Safety Precautions

WARNINGS: Fuel may not give adequate warning before toxic or harmful effects arise. Exposure to fuel can be harmful and can cause severe health damage or death. Extreme care must be exercised when handling hot fluids. Always wash off spilled fluids from affected areas of skin immediately. Hig

© 2011-2024 Copyright www.rrevoque.org