Mercedes-Benz GLK-Class: Preparing the cargo net - Cargo net - Stowage areas - Stowing and features - Mercedes-Benz GLK-Class Owner's ManualMercedes-Benz GLK-Class: Preparing the cargo net

The cargo net can be used in two different positions (behind the B-pillar or the C-pillar).

  • The brackets behind B-pillar : are required for the cargo compartment enlargement (). The corresponding cargo tie down rings to tighten the net are located in the footwell of the rear bench seat ().
  • The brackets behind C-pillar ; are required for the cargo compartment behind the rear bench seat.

The corresponding cargo tie down rings to tension the net are located in the cargo compartment ().

The cargo net is located in the loading tray in the stowage well under the trunk floor ().

  • Open both Velcro fasteners and remove the cargo net.
  • Unroll and unfold the cargo net. The upper and lower guide rods must engage audibly.
    Important safety notes
    WARNING Make sure the cargo net is properly engaged at top and bottom position and the tightening belts are securely fastened. Never use a damaged cargo net. Always use cargo net when transpo ...

    Attaching the cargo net
    Cargo net attached behind the C-pillar Insert guide rod 2 into retainer 1 in the direction of the arrow. Slide guide rod 2 forwards into retainer 1 in the direction of the arrow. ...

    See also:

    Interior mirror
    The interior rearview mirror has two pivot points on the support arm which lets you adjust the mirror up or down and from side to side. WARNING: Do not adjust the mirror while the vehicle is in mo ...

    Set or increase cruise speed
    When setting the cruise control to the speed limit, it is important to remember that it is possible for the vehicle speed to increase when travelling downhill. This may result in the vehicle sp ...

    Jacking Instructions
    Jacking Instructions 1) Place the vehicle on level, hard ground. 2) Set the parking brake firmly and shift into “P” (Park) if your vehicle has an automatic transmission, or shift into “R ...