Jeep Liberty: Preparations For Jacking - Jacking And Tire Changing - What To Do In Emergencies - Jeep Liberty Owner's ManualJeep Liberty: Preparations For Jacking

1. Park the vehicle on a firm level surface as far from the edge of the roadway as possible. Avoid icy or slippery areas.

WARNING!
Do not attempt to change a tire on the side of the vehicle close to moving traffic, pull far enough off the road to avoid being hit when operating the jack or changing the wheel.

2. Turn on the Hazard Warning flasher.

3. Set the parking brake.

4. Place the shift lever into PARK (automatic transmission) or REVERSE (manual transmission).

5. Turn the ignition to the LOCK position.

6. Block both the front and rear of the

6. Block both the front and rear of the wheel diagonally opposite of the jacking position. For example, if changing the right front tire, block the left rear wheel.

NOTE: Passengers should not remain in the vehicle when the vehicle is being jacked.

    Spare Tire Removal
    Fit the jack handle extension over the drive nut located in the rear cargo area inside the vehicle. Use the lug wrench to rotate the nut counterclockwise until the spare is on the ground with en ...

    Jacking Instructions
    WARNING! Carefully follow these tire changing warnings to help prevent personal injury or damage to your vehicle: • Always park on a firm, level surface as far from the edge of the roadway ...

    See also:

    Cornering light function
    The cornering light function improves the illumination of the road over a wide angle in the direction you are turning, enabling better visibility in tight bends, for example. It can only be acti ...

    The alarm system
    The alarm is automatically armed whenever the vehicle is locked with the remote key or optional Personal Car Communicator. When armed, the alarm continuously monitors a number of points on the ...

    Brake fluid
    Location of the brake fluid reservoir Checking the level The fluid reservoir is concealed under the round cover at the rear of the engine compartment. The round cover must be removed first be ...