Subaru Forester: Parking brake
To set the parking brake, depress the brake pedal firmly and hold it down until the parking brake lever is fully pulled up.
To release the parking brake, pull the lever up slightly, press the release button, then lower the lever while keeping the button pressed.
When the parking brake is set while the engine is running, the parking brake warning light illuminates. After starting the vehicle, be sure that the warning light has turned off before the vehicle is driven.
Refer to “Brake system warning light”.
Never drive while the parking brake is set because this will cause unnecessary wear on the brake linings.
Before starting to drive, always make sure that the parking brake has been fully released.
Parking tips
When parking your vehicle, always perform the following procedure. - Apply the parking brake firmly. - For MT models, put the shift lever in the “1” (1st) position when on an upgrade or th ...See also:
Clearing the programmed information
Individual buttons cannot be cleared, however to
clear all programming, push and hold the two
outside buttons and release when the indicator
light begins to flash (in approximately 20
seconds) ...
Lights
Have someone observe the operation of exterior lights
while you work the controls. Check turn signal and high
beam indicator lights on the instrument panel. ...
Washing the exterior
Wash your vehicle regularly with cool or lukewarm water and a neutral
pH shampoo, such as Motorcraft Detail Wash (ZC-3-A), which is
available from your authorized dealer.
• Never use strong house ...