Ford Escape: Panel dimmer control
Use to adjust the brightness of the instrument panel and all applicable switches in the vehicle during headlamp and parking lamp operation.
• Move the control to the full
upright position, past detent, to
turn on the interior lamps.
• Rotate to full down position (past
detent) to prevent interior lamps
from illuminating when the doors are opened.
Note: If the battery is disconnected, discharged, or a new battery is installed, the dimmer switch requires re-calibration. Rotate the dimmer switch from the full dim position to the full dome/on position to reset.
This will ensure that your displays are visible under all lighting conditions.
Daytime running lamps (DRL) (if equipped)
Turns the low beam headlamps on with a reduced output. To activate: • the ignition must be in the on position. • the headlamp control must be in the off, parking lamps or autolamp position ...Aiming the headlamps
The headlamps on your vehicle are properly aimed at the assembly plant. If your vehicle has been in an accident, the alignment of your headlamps should be checked by your authorized dealer. Verti ...See also:
Low beam light bulbs
Right-hand side
1. Use a screwdriver to undo the clips on
the air intake duct, then remove the air
intake duct (right-hand side).
Left-hand side
2. Use a screwdriver to remove the
secured ...
Playback of MP3/WMA Files
When a medium containing MP3/WMA data is loaded,
the radio checks all files on the medium. If the medium
contains a lot of folders or files, the radio will take more
time to start playing the MP ...
Driving tips
Observe the notes on ESP® trailer stabilization ().
The maximum permissible speed for vehicle/ trailer combinations depends on the
type of trailer. Before beginning the journey, check the trail ...