Nissan Rogue: Operations after activation
- When the rear view is displayed on the left side on the screen (B or C ), the view on the right side switches between the bird’seye view B and the front-side view C each time the CAMERA button is pushed (3 ).
- When the front view/bird’s-eye view D is displayed on the screen, pushing the CAMERA button (9 ) will switch the view on the right side to the front-side view E .
When the CAMERA button is pushed again (10 ), the screen which was displayed before the Around View Monitor was activated A is displayed.
- The view on the driver’s side switches to the rear view (B or C ) when the selector lever is shifted into the “R” (Reverse) position (5 or 7 ).
The view will switch back to the front view (D or E ) when the selector lever is shifted out of the “R” (Reverse) position (4 or 6 ).
Activating Around View Monitor
Selector lever operation: - When the selector lever is shifted into the “R” (Reverse) position (1 ) while a screen other than the Around View Monitor A is displayed, Around View Monitor is ...How to see each view
- The distance guide line and the vehicle width line should be used as a reference only when the vehicle is on a paved, level surface. The distance viewed on the monitor is for reference ...See also:
Full Size Spare – If Equipped
The full size spare is for temporary emergency use only.
This tire may look like the original equipped tire on the
front or rear axle of your vehicle, but it is not. This spare
tire may have limi ...
Heating
Heating
To direct warm air toward the floor:
1. Set the air inlet selection button to the
OFF position.
2. Set the airflow control dial to the “”
position.
3. Set the temperature cont ...
General Cleaning
Careful vacuuming of the top before washing is helpful
in removing dust and other foreign particles.
If Hand Washing:
• Wash in partial shade instead of direct sun.
• Wet the entire vehicle b ...