Jeep Liberty: Normal Starting
NOTE: Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accelerator pedal.
Turn the ignition switch to the START position and release when the engine starts. If the engine fails to start within 10 seconds, turn the ignition switch to the LOCK position, wait 10 to 15 seconds, then repeat the “Normal Starting” procedure.
Tip Start Feature
Turn the ignition switch to START position and release it as soon as the starter engages. The starter motor will continue to run, but will automatically disengage itself when the engine is running. If the engine fails to start, the starter will disengage automatically in 10 seconds. If this occurs, turn the ignition switch to the LOCK position, wait 10 to 15 seconds, then repeat the “Normal Starting” procedure.
Starting Procedures
Before starting your vehicle, adjust your seat, adjust both inside and outside mirrors, and fasten your seat belts. WARNING! • When leaving the vehicle, always remove the key fob from the ign ...Extreme Cold Weather (Below –20°F Or –29°C)
To ensure reliable starting at these temperatures, use of an externally powered electric engine block heater (available from your authorized dealer) is recommended. ...See also:
Adverse safety consequences of under-inflation
Driving at high speeds with excessively
low tire pressures can cause
the tires to flex severely and to
rapidly become hot. A sharp in-
crease in temperature could cause
tread separation, and ...
Turn Signal and Headlights
1. Turn Signal
2. OFF
3. Parking and interior lights
4. AUTO
5. Headlights on
6. High Beams
7. Flash high beams
*: If equipped
Turn Signal - Push down on the
lever to signal a left turn ...
Information Display
Information Display
(1) Clock. (2) Thermometer. (3) Instantaneous fuel consumption/Average fuel
consumption/Driving range. (4) “H” button. (5) “M” button. (6) “DISP” button. (7)
Free ...