Volvo XC60: Messages - Parking brake - Your driving environment - Volvo XC60 Owner's ManualVolvo XC60: Messages

Park brake not fully released – A fault is preventing

Park brake not fully released – A fault is preventing the parking brake from being released.

Try to apply the parking brake and release it several times. If the problem persists, contact an authorized Volvo workshop. If you drive off with this error message showing, a warning signal sounds.

Parking brake not applied – A fault is preventing the parking brake from being applied.

Try to apply the parking brake and release it several times. If the problem persists, contact an authorized Volvo workshop. If you drive off with this error message showing, a warning signal sounds.

Parking brake Service required – A fault has occurred. Try to apply and release. Contact a Volvo workshop if the fault remains.

WARNING
If the vehicle must be parked before the fault has been corrected, always put the gear selector in P and turn the wheels so that they point away from the curb if the vehicle is pointing uphill or toward the curb if it is pointing downhill.

    Symbols
    ...

    See also:

    Operating Instructions — Voice Command System (If Equipped)
    For the radio, Refer to “Voice Command” in the Uconnect™ User Manual located on the DVD for further details. ...

    Remote control
    A remote control is included with the RSE system, which can be used to control both screens in the rear seat as well as other infotainment system functions. See page 254 for more detailed infor ...

    To decrease the speed (by button)
    To decrease the speed (by button) Push the “SET/COAST” button and hold it until the vehicle reaches the desired speed. Then, release the button. The vehicle speed at that moment will be ...