Volvo XC60: Limitations
The sensor used by City Safetyâ„¢ is designed to detect cars and other larger motor vehicles ahead of your vehicle in both daylight and darkness.
However, there are certain limitations and the laser sensor’s function may be reduced by, for example, heavy rain or snowfall, or by dense fog or thick, blowing dust or snow. Condensation, dirt, ice or snow on the windshield may also interfere with the sensor’s function.
Objects such as warning flags hanging from long objects on the roof or accessories such as auxiliary lights or protective arches on the front of the vehicle that are higher than the hood may also impede the sensor’s function.
Braking distance to the vehicle ahead increases on slippery road surfaces, which may reduce City Safety’s capacity to avoid a collision.
In situations like this, the DSTC system (see page 149) will help provide the best possible braking capacity and stability.
City Safetyâ„¢ emits infrared light and measures the way in which the light is reflected. Therefore, vehicles or objects with low-reflective surfaces may not be detected. Normally, the license plate and taillight reflectors give the rear section of a vehicle ahead sufficient reflective surfaces to be detected.
NOTE
• Keep the windshield in front of the laser
sensor free of ice, snow, dirt, etc. See
page 168.
• Snow or ice on the hood deeper than
2 inches (5 cm) may obstruct the sensor.
Keep the hood free of ice and snow.
• Do not mount or in any way attach anything
on the windshield that could
obstruct the laser sensor.
Using City Safety
NOTE The City Safetyâ„¢ function is activated automatically each time the engine has been switched off and restarted. On and Off In certain situations, it may be desirable to switch City Safe ...Troubleshooting
If Windscreen Sensors blocked appears in the information display, this indicates that the City Safetyâ„¢ laser sensor is obstructed in some way and cannot detect vehicles ahead of you, which m ...See also:
Buttons on the remote
Lock – Press
the Lock button on the
remote once to lock all doors and the tailgate.
The turn signals will flash once to confirm locking.
Unlock –
Press the Unlock button on the
remote ...
Replacing headlamp bulbs
1. Make sure the headlamp control is in the off position.
2. Open the hood.
3. Reach over the front bolster.
4. Remove the bulb by turning it
counterclockwise and then pulling it
straight out.
...
Conditions affecting operation
Vehicles without smart key system
The wireless remote control function may not operate normally in the
following
situations.
●Near a TV tower, radio station, electric power plant, airport o ...