Range Rover Evoque: Isofix anchor points (not Australia)
Do not attempt to fit ISOFIX
restraints
to the centre rear seating position.
The anchor bars are not designed to
hold an ISOFIX restraint in this
position.
If the restraint is not correctly
anchored, there is a significant risk of
injury to the child in the event of a
collision or emergency braking.
Both of the outer seat positions on the rear seat
are equipped to accept ISOFIX restraints.
This symbol is shown on a label
sewn into the seats to indicate the
position of the ISOFIX lower
anchorages.
READ NEXT:
Isofix child seat positions
- IUF = Suitable for ISOFIX forward child
restraint systems of universal category
approved for use in the mass group.
- IL = These ISOFIX child restraint systems
are
In a situation where a child is too large to fit
into a child safety seat but is still too small to
safely use just the three point belt, a booster
seat is recommended for maximum safety.
Follow t
Installing an isofix child seat
To install an ISOFIX child seat:
1. Locate the ISOFIX locking mechanism.
2. Slide the child seat into the locking
mechanism.
3. If an upper tether is fitted to t
SEE MORE:
See 197, WEIGHTS, for details of the Gross
Vehicle Weight (GVW), Gross train weight
(GTW), axle weights and maximum payload.
Europe only:
When towing, the maximum permissible Gross
Vehicle Weight can be increased by a
maximum of 100kg (220lb) provided that the
road speed is limited to 97km/
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the LH rear wheel and tire.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and
Installation).
3. Refer
© 2011-2024 Copyright www.rrevoque.org