Nissan Rogue: Instrument brightness control
The instrument brightness control operates when the headlight switch is in the or position.
Turn the control A to adjust the brightness of the meter panel and the instrument panel lights.
The brightness indicator B will be shown briefly in the vehicle information display when the control is turned.
When the brightness level reaches the maximum or minimum, a beep will sound.
When the brightness level reaches the minimum, the meter panel and the instrument panel lights will be turned off.
After the ignition switch is turned to the OFF position, the brightness indicator B is displayed for 30 seconds.
Fuel gauge
The gauge A indicates the approximate fuel level in the tank. The gauge may move slightly during braking, turning, acceleration, or going up or down hills. Refill the fuel tank before the gaug ...Compass (if so equipped)
When the ignition switch is turned to the ON position, the compass display B will indicate the direction of the vehicle’s heading. If the display reads “C”, calibrate the compass by d ...See also:
Vehicle Security System
The vehicle security system provides visual and
audio alarm signals if someone opens the doors,
or lift gate when the system is armed. It is not,
however, a motion detection type system that
a ...
Geartronic–manual shifting
Geartronic allows you to manually shift among
your vehicle's six forward speeds. Geartronic
can be selected at any time.
• To access the manual shifting position
from Drive (D), move the gear ...
Tire sealing system–temporarily repairing a flat tire
Tire sealing system–temporarily repairing a flat tire
Temporarily repairing a flat tire is done in two
stages:
• Stage 1: The hole is sealed by pumping
sealing compound into the tire. The ...