Volvo XC60: Installing the ball holder
1. If necessary, remove the cotter pin from the locking bolt and slide the locking bolt out of the hitch assembly.
2. Slide the ball holder into the hitch assembly.
3. Align the hole in the ball holder with the one in the hitch assembly.
4. Slide the locking bolt through the hitch assembly/ball holder.
5. Insert the cotter pin in the hole at the end of the locking bolt.
Detachable trailer hitch (accessory)
Detachable trailer hitch (accessory) a Ball holder b Locking bolt c Cotter pin d Hitch assembly e Safety wire attachment ...Removing the ball holder
1. Remove the cotter pin from the locking bolt and slide the locking bolt out of the ball holder/hitch assembly. 2. Pull the ball holder out of the hitch assembly. NOTE A cover for the hitch as ...See also:
Brake Fluid
The brake master cylinder reservoir is filled with DOT 3 brake fluid as indicated
on the reservoir cap. See Engine Compartment Overview on page 10‑6 for the location
of the reservoir.
The ...
Vehicle storage
If you plan on storing your vehicle for an extended period of time
(30 days or more), refer to the following maintenance recommendations
to ensure your vehicle stays in good operating condition.
...
Windshield Wipers And Washers
The windshield wiper/washer control lever is located on
the right side of the steering column. The front wipers are
operated by rotating a switch, located at the end of the
lever. For informatio ...