Dodge Nitro: If your engine overheats - What to do in emergencies - Dodge Nitro Owner's ManualDodge Nitro: If your engine overheats

In any of the following situations, you can reduce the potential for overheating your engine by taking the appropriate action.
• On the highways — slow down.
• In city traffic — while stopped, put transmission in NEUTRAL, but do not increase engine idle speed.

CAUTION: Driving with a hot cooling system could damage your vehicle. If the temperature gauge reads “H,” pull over and stop the vehicle. Idle the vehicle with the air conditioner turned off until the pointer drops back into the normal range. If the pointer remains on the “H” and you hear continuous chimes, turn the engine off immediately and call for service.

NOTE: There are steps that you can take to slow down an impending overheat condition:
• If your air conditioner (A/C) is on, turn it off. The A/C system adds heat to the engine cooling system and turning the A/C off can help remove this heat.
• You can also turn the temperature control to maximum heat, the mode control to floor and the blower control to high. This allows the heater core to act as a supplement to the radiator and aids in removing heat from the engine cooling system.

WARNING: You or others can be badly burned by hot engine coolant (antifreeze) or steam from your radiator. If you see or hear steam coming from under the hood, do not open the hood until the radiator has had time to cool. Never try to open a cooling system pressure cap when the radiator or coolant bottle is hot.

    Hazard warning flasher
    The Hazard Warning Flasher switch is located on the lower switch bank below the climate controls. Press the switch to turn on the Hazard Warning flasher. When the switch is activated, all direc ...

    Jacking and tire changing
    WARNING: • Getting under a jacked-up vehicle is dangerous. The vehicle could slip off the jack and fall on you. You could be crushed. Never get any part of your body under a vehicle that is ...

    See also:

    Initializing the registered data
    To initialize the registered data, perform the following procedure. 1. Select the “INITIALIZE” menu. 2. Select the “CONFIRM” menu. First “PLEASE WAIT”, then “INITIALIZED” is di ...

    RearView monitor (if so equipped)
    When the selector lever is shifted into the R (Reverse) position, the monitor display shows the view to the rear of the vehicle. The system is designed as an aid to the driver in detecting larg ...

    Entretien et soin
    ■Ceintures de sécurité Nettoyez avec un chiffon ou une éponge humectée d'eau savonneuse tiède. Profitez de l'occasion pour vérifier réguli&egra ...