Range Rover Evoque: If the engine fails to start
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / If the engine fails to start
Note: If the engine fails to crank when the START/STOP button is pressed and there has been a recent collision, seek qualified assistance.
If the engine fails to crank, or fails to start, consult your Dealer/Authorised Repairer.
Diesel engines:
If the engine persistently fails to start, make sure the transmission is in P or N (neutral for manual transmission vehicles) then press the START/STOP button (with the brake pedal applied). Keep the START/STOP button and the brake pedal pressed until the engine starts, then release.
If the engine still fails to crank, or fails to start consult your Dealer/Authorised Repairer.
READ NEXT:
Switching off the engine
Before switching off the engine, ensure that the
vehicle is parked safely with the park brake
applied.
1. Select P for automatic transmission, or
neutral for manual transmissions.
Note: If any ot
Switching off the engine with the vehicle moving
It is not advisable to switch
off the
engine while the vehicle is moving.
However, should such a situation
arise, then the following procedure
applies.
- Press and hold the engine START/STOP
Rolling re-start
If the engine is switched off while the vehicle is
moving, a rolling re-start can be initiated.
Automatic transmission - select neutral (N) and
then press the engine START/STOP button.
When the en
SEE MORE:
Stalled adjustment
If seat
movement stops unexpectedly
during adjustment check for any
obstructions and remove.
Once any obstructions have been removed the
seat adjustment mechanism can be reset as
follows.
Operate the button again to continue the stalled
adjustment. When seat movement resumes
hold the butt
Suspension Top Mount
Removal
NOTES:
The suspension top mount is manufactured from mild steel and RP220.
The service panel is serviced not fully spot welded.
The panel is serviced less its weld studs
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on an
approved alignment jig.
2.
© 2011-2024 Copyright www.rrevoque.org
