Subaru Forester: High beam light bulbs - Headlights (models without HID headlights) - Replacing bulbs - Maintenance and service - Subaru Forester Owner's ManualSubaru Forester: High beam light bulbs

Right-hand side
Right-hand side

1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct (right-hand side).

2. Disconnect the electrical connector

2. Disconnect the electrical connector from the bulb.

3. Remove the bulb from the headlight

3. Remove the bulb from the headlight assembly by turning it counterclockwise.

4. Replace the bulb with new one. At this time, use care not to touch the bulb surface.

5. To install the bulb to the headlight assembly, turn it clockwise until it clicks.

6. Reconnect the electrical connector.

7. Install the air intake duct with clips (right-hand side).

    Low beam light bulbs
    Right-hand side 1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct (right-hand side). Left-hand side 2. Use a screwdriver to remove the secured ...

    Position light
    1. Turn the bulb socket counterclockwise and pull out the socket. 2. Pull the bulb out of the socket. 3. Install a new bulb. 4. Install the bulb socket by turning it clockwise. ...

    See also:

    Arming the System
    To arm the system, do one of the following: ○ Press on the RKE transmitter. ○ Lock the vehicle using the key in the driver door. The alarm automatically arms after about 30 seconds. Th ...

    Vehicle Storage
    Tires age when stored normally mounted on a parked vehicle. Park a vehicle that will be stored for at least a month in a cool, dry, clean area away from direct sunlight to slow aging. This area sh ...

    Switching off the engine with the vehicle moving
    It is not advisable to switch off the engine while the vehicle is moving. However, should such a situation arise, then the following procedure applies. - Press and hold the engine START/STOP ...