Hyundai Tucson: Heating controls
For normal heating operation, set the air intake
control to the fresh air (
) position and
the
air flow control to the floor (
)
position.
For faster heating, the air intake control should
be set in the recirculate (
) position.
If the windows fog up, set the air flow control to
the defrost (
) position. (The A/C will be
on
automatically and "Fresh" mode will be activated.)
For maximum heat, rotate the temperature
control to "Warm".
Heating and ventilation
There are three controls and two switches for
the heating and cooling system. They are:
1. Air flow control.
2. Fan speed control.
3. Temperature control.
4. Air intake control switch.
5 ...
Bi-level heating
Your Hyundai is equipped with bi-level heating
controls. To use this feature:
o Set the air intake control to the fresh air
() position.
o Set the air flow control at the bi-level ()
posit ...
See also:
Meter needles/gauge illumination setting (models with type A combination
meter)
When the setting is activated or deactivated,
the meter needles and gauge
illuminate and turn off as follows.
Activated:
When the driver’s door is opened while
the ignition switch is in the ...
Low tire pressure warning light (U.S.-spec. models)
When the ignition switch is turned to the
“ON” position, the low tire pressure warning
light will illuminate for approximately 2
seconds to check that the tire pressure
monitoring syst ...
In Canada
If you believe that your vehicle has a safety defect, you
should contact the Customer Service Department immediately.
Canadian customers who wish to report a safety
defect to the Canadian governm ...
