Subaru Forester: Headlight flasher
Headlight flasher
To flash the headlights, pull the lever toward you and then release it. The high beam will remain on for as long as you hold the lever. The headlight flasher works even though the light switch is in the “OFF” position.
When the headlights are on high beam, the high beam indicator light “” on the combination meter also illuminates.
Do not hold the lever in the flashing position for more than just a few seconds.
High/low beam change (dimmer)
High/low beam change (dimmer) To change from low beam to high beam, push the turn signal lever forward. When the headlights are on high beam, the high beam indicator light “” on the c ...Daytime running light system (if equipped)
The brightness of the illumination of the high beam headlights is reduced by the daytime running light system. The light switch must always be turned to the “” position when it is ...See also:
Tire pressure monitoring system (TPMS) (U.S.-spec. models)
The tire pressure monitoring system provides
the driver with a warning message
by sending a signal from a sensor that is
installed in each wheel when tire pressure
is severely low. The tire pr ...
Ensembles
Unlike AM/FM radio, DAB transmits several
channels/stations on a single frequency. A
group of channels is known as an ensemble.
Some channels within the ensemble may have
subchannels offering seve ...
Detachable tow ball
Fit and remove instructions are supplied with
this accessory fit item. Ensure that they are
kept in a safe place. ...