GMC Terrain: Headlamps, Front Turn Signal, Sidemarker, and Parking Lamps
A. Low-Beam Headlamp
B. High-Beam Headlamp
C. Sidemarker Lamp
D. Park/Turn Signal Lamp
To replace one of these bulbs:
1. Turn the tire to reach the access port cap located in the front of wheel well cover.
A. Screw
B. Access Port Cap
2. Remove the screw (A) and turn the access port cap (B) counterclockwise to remove.
3. If replacing a headlamp bulb, remove the dust cover cap from the back of the headlamp housing by turning the cap counterclockwise.
4. Turn the bulb socket counterclockwise to remove it from the lamp assembly.
5. Remove the bulb from the socket or disconnect the bulb assembly from the harness
connector.
6. Install the new bulb.
7. Reinstall the bulb socket to the lamp assembly, turning clockwise.
8. Replace the dust cover cap on headlamps.
9. Reinstall the wheel well cover access port cap and secure by installing the screw.
Bulb Replacement
For the proper type of replacement bulbs, see Replacement Bulbs on page 10‑37. For any bulb changing procedure not listed in this section, contact your dealer. ...Fog Lamps
To replace one of these bulbs: 1. Locate the fog lamp assembly under the front facia. 2. Disconnect the bulb socket from the electrical connector, turn, and pull out the bulb assembly. 3. Remov ...See also:
Washer fluid
Open the washer fluid reservoir cap and check the level of washer fluid with
the dipstick. If the level is low, replenish the container with washer fluid.
NOTE:
● The washer fluid contain ...
Instruction labels for tires and loads
WARNING
Do not overload the tires by exceeding the specified load limit as indicated
on the Tire and Loading Information placard on the driver's door B-pillar. Overloading
the tires can ...
Any questions?
If you have any questions about the care of your
car, consult your Hyundai dealer.
R : Replace I : Inspect and, after inspection, clean, adjust, repair or
replace if necessary
Note : (1) When ...