Mercedes-Benz GLK-Class: Automatic transmission
WARNING
It is dangerous to shift the automatic transmission out of parking position P or neutral position N if the engine speed is higher than idle speed. If your foot is not firmly on the brake pedal, the vehicle could accelerate quickly forward or in reverse. You could lose control of the vehicle and hit someone or something. Only shift into gear when the engine is idling normally and when your right foot is firmly on the brake pedal.
It is only possible to shift the transmission from position P to the desired position if you depress the brake pedal. Only then is the selector lever lock released.
- Depress the brake pedal and keep it depressed.
- Shift the transmission to position D or R.
- Release the parking brake ().
- Release the brake pedal.
- Carefully depress the accelerator pedal.
If a warning tone sounds and the Release Park. Brake message appears in the multifunction display, the parking brake is still applied. Release the parking brake.
The vehicle locks centrally once you have pulled away. The locking knobs in
the doors drop down.
You can open the doors from the inside at any time.
You can also deactivate the automatic locking feature ().
Upshifts take place at higher engine speeds after a cold start. This helps the catalytic converter to reach its operating temperature more quickly.
Pulling away
...Hill start assist
Hill start assist helps you when pulling away forwards or in reverse on an uphill gradient. It holds the vehicle for a short time after you have removed your foot from the brake pedal. This gives ...See also:
Interior lamps
1- Luggage room lamp 2- Room lamp (rear). 3- Map & room lamps (front). 4- Foot
lamps* P. 8-58.
NOTE:
● If you leave the lamps on without running the engine, you will run down the batt ...
Driving
This section gives you tips on
starting the engine under various
conditions, and how to operate the
automatic transmission. It also
includes important information on
parking your vehicle, th ...
Initialization
When the ignition switch is placed in the ON
position, NISSAN Voice Recognition is initialized,
which takes a few seconds. If the
button is pushed before the initialization completes,
the sys ...