Volvo XC60: Extra high beam
1. Remove the headlight housing from the vehicle (see page 322).
2. Remove the cover over the bulbs (see page 323).
3. Disconnect the wiring connector from the bulb holder.
4. Remove the bulb holder from the headlight housing by pulling it straight out.
5. Insert a new bulb in the holder until it snaps in place. It can only be inserted in one way.
6. Press the bulb holder into position in the headlight housing.
7. Reconnect the wiring connector to the bulb holder.
8. Put the cover back into position and reinstall the headlight housing.
High beam, Halogen
1. Remove the headlight housing from the vehicle (see page 322). 2. Remove the cover over the bulbs (see page 323). 3. Remove the bulb by turning it counterclockwise and pulling it straight ...Turn signals
1. Remove the headlight housing from the vehicle (see page 322). 2. Remove the bulb holder by turning it counterclockwise and pulling it out of the headlight housing. 3. Pull out the holder ...See also:
Windshield wiper blades
The wiper blades should be carefully inspected
from time to time and cleaned to remove accumulations
of road film or other debris. To clean
the wiper blades and arms, use a clean sponge
or c ...
Trailer lights
When splicing into the vehicle electrical
system, a commercially available
power-type module/converter must be
used to provide power for all trailer
lighting. This unit uses the vehicle
...
If you park your vehicle in case of an emergency
The hazard warning flasher should be
used in day or night to warn other drivers
when you have to park your vehicle under
emergency conditions.
Avoid stopping on the road. It is best to
sa ...