Ford Escape: Erasing the Car2U Home Automation System buttons
Note: The system allows for three devices to be programmed. If you need to change or replace any of the three devices after it has been initially programmed, it will be necessary to erase the current settings using the procedure below and then reprogramming all of the devices being used.
To erase programming on the Car2U system (individual buttons cannot be erased), use the following procedure:
1. Firmly press the two outside Car2U system buttons simultaneously for approximately 20 seconds until the indicator lights begin to blink rapidly. The indicator lights are located directly above the buttons.
2. Once the indicator lights begin to blink, release your fingers from the buttons. The codes for all buttons are erased.
If you sell your vehicle equipped with the Car2U system, it is recommended that you erase the programming for security reasons.
Fixed code programming
Note: Do not program the Car2U system with the vehicle in the garage. Make sure that your key is on and engine off while programming the transmitter. 1. To program units with fixed code DIP swi ...FCC and RSS-210 Industry Canada Compliance
The Car2U system complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, ...See also:
Windshield wiper service position
The windshield wipers must be in the service
position before the wiper blades can be
cleaned or replaced. See page 329 for additional
information. ...
Front-side view
Front-side view
Guiding lines:
Guiding lines that indicate the width and the
front end of the vehicle are displayed on the
monitor.
The front-of-vehicle line 1 shows the front part
of the v ...
NECK-PRO head restraints
The NECK-PRO head restraints increase protection to the driver's and front passenger's
head and neck. To this end, the NECK-PRO head restraints on the driver's and front-passenger
seat ...