Range Rover Evoque: Engine starting: automatic transmission
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Engine starting: automatic transmission
1. A valid Smart Key must be inside the vehicle.
2. Make sure the gear selector is in P or N.
3. Firmly depress the brake pedal.
4. Press and release the start button. The engine will crank automatically until it starts. For diesel engined vehicles there may be a delay while the glow plugs warm up, then the engine will crank automatically until it starts.
READ NEXT:
Engine starting: manual transmission
Note: Do not press the accelerator pedal when
starting the engine.
1. A valid Smart Key must be inside the
vehicle.
2. Fully depress the clutch pedal.
3. Press and release the start button. For
If the engine fails to start
Note: If the engine fails to crank when the
START/STOP button is pressed and there has
been a recent collision, seek qualified
assistance.
If the engine fails to crank, or fails to start,
consult
Switching off the engine
Before switching off the engine, ensure that the
vehicle is parked safely with the park brake
applied.
1. Select P for automatic transmission, or
neutral for manual transmissions.
Note: If any ot
SEE MORE:
Jacking
General
WARNING: The
following instructions must be adhered to before raising the vehicle off the
ground:
Position vehicle on a solid, level surface.
Apply the parking brake.
Select 'P' - PARK on automatic transmission selector.
Select 'N' - Neutral on manual transmission.
WARNING: If
the
Front Stabilizer Bar Bushing
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the front wheels
© 2011-2024 Copyright www.rrevoque.org
