Dodge Nitro: Engine block heater
The engine block heater warms the engine, and permits
quicker starts in cold weather. Connect the cord to a
standard 110-115 Volt AC electrical outlet with a
grounded three-wire extension cord.
• The engine block heater cord is found under the hood
clipped to the heater line on the left side of the engine.
WARNING: Remember to disconnect the cord before driving. Damage to the 110-115 Volt AC electrical cord could cause electrocution.
Use the heater when temperatures below 0 °F (-18 °C) are expected to last for several days.
Starting procedures
Before starting your vehicle, adjust your seat, adjust both inside and outside mirrors, and fasten your seat belts. WARNING: Never leave children alone in a vehicle. Leaving children in a vehic ...Automatic transmission
CAUTION: Damage to the transmission may occur if the following precautions are not observed: • Shift into PARK only after the vehicle has come to a complete stop. • Shift into or out of ...See also:
Clear MyKey
To reset all MyKeys as admin keys do the following:
1. Turn the vehicle on using the admin key.
2. Press SETUP until PRESS RESET TO CLEAR MYKEY is displayed.
3. Press and release the RESET button ...
Temperature A B C
The temperature grades are A (the highest), B and C, representing the
tire’s resistance to the generation of heat and its ability to dissipate heat
when tested under controlled conditions on a spe ...
Washing the Vehicle
To preserve the vehicle's finish, wash it often and out of direct sunlight.
Notice: Do not use petroleum based, acidic, or abrasive cleaning agents as they
can damage the vehicle's paint, m ...