Volvo XC60: Engine and cooling system - General information - Driving recommendations - During your trip - Volvo XC60 Owner's ManualVolvo XC60: Engine and cooling system

Under special conditions, for example when driving in hilly terrain, extreme heat or with heavy loads, there is a risk that the engine and cooling system will overheat. Proceed as follows to avoid overheating the engine.

• Maintain a low speed when driving with a trailer up long, steep hills.

• Do not turn the engine off immediately when stopping after a hard drive.

WARNING
The cooling fan may start or continue to operate (for up to 6 minutes) after the engine has been switched off.

• Remove any auxiliary lights from in front of the grille when driving in hot weather conditions.

• Do not exceed engine speeds of 4500 rpm if driving with a trailer in hilly terrain. The oil temperature could become too high.

    Driving through water
    • The vehicle can be driven through water up to a depth of approximately 10 in. (25 cm), at a maximum speed of 6 mph (10 km/h). • Take particular care when driving through flowing water. â ...

    Conserving electrical current
    Keep the following in mind to help minimize battery drain: • When the engine is not running, avoid using ignition mode II. Many electrical systems (the audio system, the optional navigation ...

    See also:

    SRS warning lamp
    SRS functions are checked regularly when you switch on the ignition and when the engine is running. Therefore, malfunctions can be detected in good time. The SRS warning lamp in the instrument c ...

    Full Size Spare – If Equipped
    The full size spare is for temporary emergency use only. This tire may look like the original equipped tire on the front or rear axle of your vehicle, but it is not. This spare tire may have limi ...

    Removing the vehicle battery
    Special tools are required to refit the battery after removal, therefore battery removal and refit should be carried out only by qualified personnel. Consult your Dealer/Authorised Repairer. ...