Ford Escape: Easy Fuel “no cap” fuel system - What you should know about automotive fuels - Maintenance and Specifications - Ford Escape Owner's ManualFord Escape: Easy Fuel “no cap” fuel system

Your fuel tank is equipped with an Easy Fuel “no cap” fuel filler system.

This allows you to simply open the fuel filler door and insert the fuel filler nozzle into the fuel system. The Easy Fuel system is self-sealing and protected against dust, dirt, water and snow/ice.

When fueling your vehicle:

1. Turn the engine off.
2. Open the fuel filler door.
3. Slowly insert the fuel filler nozzle fully into the fuel system, and leave the nozzle fully inserted until you are done pumping. Pump fuel as normal.
4. After you are done pumping fuel, slowly remove the fuel filler nozzle—allow about five seconds after pumping fuel before removing the fuel filler nozzle. This allows residual fuel to drain back into the fuel tank and not spill onto the vehicle.

Note: A fuel spillage concern may occur if overfilling the fuel tank. Do not overfill the tank to the point that the fuel is able to bypass the fuel filler nozzle. The overfilled fuel may run down the drain located below and in front of the fuel filler door.

If the check fuel fill inlet lamp or CHECK FUEL FILL INLET message comes on, the fuel fill inlet may not have properly closed. The inlet may have stuck open or debris may be preventing the inlet from fully closing.

At the next opportunity, safely pull off the road, turn off the engine, open the fuel filler door and remove any visible debris from the fuel fill opening. Insert either the fuel fill nozzle or the fuel fill funnel (see Refilling with a portable fuel container for funnel location) provided with the vehicle several times to dislodge any debris and/or allow the inlet to close properly. If this action corrects the problem, the check fuel fill inlet lamp or CHECK FUEL FILL INLET message may not reset immediately. It may take several driving cycles for the check fuel fill inlet lamp or CHECK FUEL FILL INLET message to turn off. A driving cycle consists of an engine start-up (after four or more hours with the engine off) followed by city/highway driving. Continuing to drive with the check fuel fill inlet lamp or CHECK FUEL FILL INLET message on may cause the service engine soon lamp to turn on as well.

a hissing sound near the fuel filler door (Easy Fuel “no cap” WARNING: The fuel system may be under pressure. If you hear a hissing sound near the fuel filler door (Easy Fuel “no cap” fuel system), do not refuel until the sound stops. Otherwise, fuel may spray out, which could cause serious personal injury.

Flex fuel vehicle (FFV) fuel fill inlet

If your vehicle is flex fuel capable, it will have a yellow bezel placed over the fuel fill inlet.

    Important safety precautions
    WARNING: Do not overfill the fuel tank. The pressure in an overfilled tank may cause leakage and lead to fuel spray and fire. WARNING: The fuel system may be under pressure. If you hear a hissing ...

    Choosing the right fuel
    If your vehicle is a flexible fuel vehicle (FFV), use only UNLEADED FUEL and FUEL ETHANOL (Ed75–Ed85). If your vehicle is not a flexible fuel vehicle (FFV), then only use UNLEADED fuel or UNLEA ...

    See also:

    Tilt Steering Column
    This feature allows you to tilt the steering column upward or downward. The tilt control handle is located below the steering wheel at the end of the steering column. Tilt Steering Control Ha ...

    Replacing spark plugs
    Replacing spark plugs If replacement is required, see a NISSAN dealer for servicing. Iridium-tipped spark plugs It is not necessary to replace the iridium-tipped spark plugs as frequently as ...

    Storing and Deleting Phone Numbers
    The system can store up to 30 phone numbers as name tags in the Hands&-Free Directory that is shared between the Bluetooth and OnStar systems. The following commands are used to delete and stor ...