Nissan Rogue: Drive belts
1. Alternator
2. Water pump
3. Drive belt auto-tensioner
4. Crankshaft pulley
5. Air conditioner compressor
Be sure the ignition switch is in the OFF or LOCK position before servicing drive belts. The engine could rotate unexpectedly.
1. Visually inspect each belt for signs of unusual wear, cuts, fraying or looseness. If the belt is in poor condition or loose, have it replaced or adjusted by a NISSAN dealer.
2. Have the belts checked regularly for condition.
Jump starting
If jump starting is necessary, see “Jump starting” in the “6. In case of emergency” section. If the engine does not start by jump starting, the battery may have to be replaced. Contact a ...Spark plugs
Be sure the engine and ignition switch are off and that the parking brake is engaged securely. Be sure to use the correct socket to remove the spark plugs. An incorrect socket can dam ...See also:
Tail lamp
Switch off the lights.
Open the cargo compartment.
Open the side trim panel ().
Pull out connector 2.
Press retaining lugs 1 simultaneously in the direction of the arrow and
pull t ...
Emission inspection and maintenance (I/M) programs
Some states have vehicle emission inspection programs which
include OBD (On Board Diagnostics) checks. The OBD system monitors
the operation of the emission control system.
■ If the malfuncti ...
Remote Start Heated Seats
When it is cold outside, the heated seats can be programmed to turn on automatically
during a remote vehicle start. The heated seats will be canceled when the ignition
is turned on. Press the heat ...