Subaru Forester: Displaying satellite radio ID of tuner
When you activate satellite radio, you should have your satellite radio tuner ID ready because each tuner is identified by its unique satellite radio tuner ID.
The satellite radio ID will be needed when you activate satellite radio and receive satellite radio customer support.
The satellite radio ID can be found on the audio display by tuning the channel to “0”.
Turn the “TUNE/TRACK/CH” dial to select the satellite radio channel.
NOTE
For Sirius, change the display to an
indication mode other than the channel
number after performing the above
operation.
XMTM satellite radio reception tips for antenna on the windshield (for U.S.A. only — if equipped)
For some models, the satellite radio antenna is fixed to the upper right hand corner of the windshield. The XMTM satellite radio receiver that is fitted to your vehicle receives the necessary ...Band selection
Push the “SAT” button when the radio is off to turn on the radio. Push the “SAT” button when the radio is on to select SAT1, SAT2 or SAT3 reception. ...See also:
Operating a Bluetooth® enabled portable player
Selecting an album
Press ( < ) or
( > ) to select the desired album.
Scanning an album
1 Press and hold until you hear
a beep.
The first 10 seconds of the first track in the each al ...
Glare from the side
Fold down the sun visor.
Pull the sun visor out of retainer 2.
Swing the sun visor to the side.
Pull or push the sun visor in the direction of the arrow.
...
Turn-signal lever
1- Turn-signals. When making a normal turn, use position (1). The lever will
return automatically when cornering is completed. 2- Lane-change signals. When moving
the lever to (2) slightly to ch ...