Ford Escape: Compass zone adjustment
1. Determine which magnetic zone
you are in for your geographic
location by referring to the zone
map.
2. Turn ignition to the on position.
3. Start the engine.
4. Press the SETUP control to select the Update Zone function and display the current ZONE XX in the center stack display.
5. Continue to press the RESET control until the correct zone appears in the center stack display.
6. The direction will display after the RESET control is released. The zone is now updated.
Electronic compass (if equipped)
The compass heading is displayed in the center stack display. The compass reading may be affected when you drive near large buildings, bridges, power lines and powerful broadcast antenna. Magnetic ...Compass calibration adjustment
Perform compass calibration in an open area free from steel structures and high voltage lines. For optimum calibration, turn off all electrical accessories (heater/air conditioning, wipers, etc.) an ...See also:
Service messages
Information on the type of service and service intervals (see separate Service
Booklet). You can obtain further information from an authorized Mercedes-Benz Center
or at http://www.mbusa.com (USA ...
Downhill assist control system
With the downhill assist control system, the vehicle is able to
descend a steep hill while maintaining a constant low speed of about
3 mph (5 km/h) without brake pedal operation.
■ Activating ...
Windshield washer system and headlamp cleaning system
The washer fluid reservoir is used for both the windshield washer system and
the headlamp cleaning system.
Vehicle components and their service products must match. You should, therefore,
only ...