Range Rover Evoque: Commandshift™
To return to Sport mode after CommandShift
has been selected, move the selector back to D
then back to Sport mode. Transmission
Commandshift Selected will appear in the
message centre when the transmission is in
CommandShift mode.
Note: In order to protect the engine, the
transmission will automatically change up to
prevent over-revving, or down if the engine is
labouring.
READ NEXT:
Push the accelerator pedal fully down to
achieve rapid acceleration in automatic mode.
When the pedal is relaxed, normal gear
changing will resume.
P should normally be selected before switching
off the engine. If any other gear is selected at
turn off, the selector will move to P before
retracting into the centre console.
If the engine is sw
If the drive selector is obstructed, remove the
obstruction and then start the engine. The
selector should elevate as normal.
If the selector still fails to elevate, even if there
is no obstructio
SEE MORE:
Special Tool(s)
303-D121
Puller, General Purpose
General Equipment
Vise
Removal
NOTE: RH inner constant velocity joint boot shown, LH is similar.
1. Refer to: Rear Halfshaft LH (205-05 Rear Drive Halfshafts, Removal
and Installation).
Refer to: Rear Halfshaft RH (205-05 Rear Drive Halfshafts, Re
Removal
NOTES:
The side panel is manufactured from mild steel. The fender mounting
bracket is serviced on the new panel.
This procedure identifies the method for the replacement of the side panel in
full. There are possible alternative sections of the side
panel that can be performed dependant on
© 2011-2024 Copyright www.rrevoque.org