Ford Escape: Clear MyKey
To reset all MyKeys as admin keys do the following:
1. Turn the vehicle on using the admin key.
2. Press SETUP until PRESS RESET TO CLEAR MYKEY is displayed.
3. Press and release the RESET button. HOLD RESET TO CONFIRM
CLEAR is displayed.
4. Press and hold the RESET button for two seconds until ALL MYKEYS
CLEARED is displayed.
Programming MyKey Optional Settings
Turn the ignition on using an admin key. To program the optional settings, use the message center buttons to do the following: 1. Press SETUP until RESET FOR MYKEY SETTINGS is displayed. 2. Press ...Check MyKey System Status
The vehicle’s message center system check will provide the status of the following MyKey parameters: • MYKEY MILES — This odometer only tracks mileage when a MyKey is used. If mileage does ...See also:
Driving on snow and ice
4WD vehicles have advantages over 2WD vehicles in snow and ice but
can skid like any other vehicle.
Should you start to slide while driving on snowy or icy roads, turn the
steering wheel in the d ...
Turn signals
1. Remove the headlight housing from the
vehicle (see page 322).
2. Remove the bulb holder by turning it counterclockwise
and pulling it out of the headlight
housing.
3. Pull out the holder ...
Jacking Instructions
Jacking Instructions
1) Place the vehicle on level, hard ground. 2) Set the parking brake firmly and
shift into “P” (Park) if your vehicle has an automatic transmission, or shift into
“R ...