Range Rover Evoque: Cleaning after off-road driving

Ensure that the areas around

air intakes Ensure that the areas around air intakes and the front grille are clean and clear of debris. Pay particular attention to the lower grille and radiator. Failure to do so may cause the engine to overheat, leading to severe engine damage.

Ensure that the vehicle underside is cleaned as soon as possible after driving off-road.

CLEANING THE ALLOY WHEELS

cleaning Only use approved wheel cleaning products.

READ NEXT:

 Glass surfaces

Clean the rear window with a soft cloth to avoid damaging the heating element. Do not scrape the glass or use any abrasive cleaning fluid. Mirror glass is particularly susceptible to damage. Wash

 Cleaning the rear screen

To avoid damaging the heating elements when cleaning the inside of the rear screen, use only a soft damp cloth or chamois leather. Do not use solvents or sharp objects to clean the glass.

 Repairing minor paint damage

Regularly inspect the paintwork for damage. Any stone chips, fractures, or deep scratches, in the paint/bodywork should be repaired promptly. Bare metal will corrode quickly, and if left untreated

SEE MORE:

 Wheel Knuckle Rear Bushing

Special Tool(s) 204-620-01 Installer, Wheel Knuckle Bushing 204-620-02 Remover/Installer, Wheel Knuckle Bushing 204-620-03 Remover, Wheel Knuckle Bushing LR-121 Hydraulic Cylinder 10t Removal 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Remove the

 Speed Control

Speed Control Actuator Removal 1. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation). Installation 1. To install, reverse the removal procedure. Speed Control Deactivator Switch Removal NOTE: Removal steps in this procedure may contain installation details. 1. CAUTI

© 2011-2024 Copyright www.rrevoque.org