Subaru Forester: Checking the oil level
1) Yellow handle
1. Park the vehicle on a level surface and stop the engine.
2. Pull out the level gauge, wipe it clean, and insert it again.
1) Upper level
2) Lower level
3. Pull out the level gauge again and check the oil level on it. If it is below the lower level, add oil to bring the level up to the upper level.
Be careful not to spill front differential gear oil when adding it. If oil touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire. If oil gets on the exhaust pipe, be sure to wipe it off.
Recommended grade and viscosity
Each oil manufacturer has its own base oils and additives. Never use different brands together. For details, refer to “Manual transmission, front differential and rear differential gear oil ...See also:
Switching the door unlock function
It is possible to set which doors the entry function unlocks.
1 Turn the “ENGINE START STOP” switch OFF.
2 When the indicator on the key surface is turned off, push and hold
for approxim ...
Emissions control system maintenance
The Scheduled Maintenance services listed in bold type
must be done at the times or mileages specified to ensure
the continued proper functioning of the emissions control
system. These and all o ...
Windshield Washer Fluid
Front and rear
(if equipped)
Check that there is washer fluid in the tank by looking at the washer fluid level
gauge which is attached to the cap of the washer fluid tank. If the fluid level
...